Vuly Thunder Pro Manual page 14

9
STEP
Take your Frame Reinforcements and prop
them over the Leaf Spring hole at the centre
of each Frame section, so that each supports
each Upper Frame Tube.
Insert Leaf Springs through the holes in the
Frame Reinforcements and into the Leaf
Spring holes.
10
STEP
A. Go around your trampoline, inserting and attaching the
remaining Leaf Springs. Do so by connecting one Leaf
Spring in each frame section, before connecting the
corresponding Leaf Spring on the opposite side of the
Jump Mat – until you have attached every Leaf Spring.
Ensure that you slip the mat connectors through the net
connector holes as you do so.
B. Twist Safety Rings onto every mat connector to fully secure
the Leaf Springs.
Net Poles
11
STEP
A. Insert each Upper Net Pole and Lower Net Pole into either
end of each Middle Net Pole.
Note: The Lower Net Pole is reinforced at the bottom. The
Middle Net Pole has a single hole at the top. The Upper Net
Pole has three holes for the Shade Cover.
B. Rest the completed Net Poles against the frame at each
12
STEP
Insert each Net Pole Plug into every Upper Net Pole.
Ensure that the materials are not twisted and that the
Upper Net Pole is facing outwards.
14
A
A
B
B