Table of Contents
Advertisement
Use
24 hours.
Charging the battery (Fig. D)
Make sure that the appliance is switched off. The battery
will not be charged with the on/off switch in the on posi-
tion.
Plug the jack plug of the charger into the charging socket
(4) of the appliance.
Plug in the charger. Switch on at the mains. The charging
indicator (3) will be lit.
Leave the appliance to charge for at least 16 hours.
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
indicator (3) will be lit as long as the appliance is connected to
the plugged-in charger.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C.
To switch the appliance on, slide the on/off switch (1)
forward to position 1.
To switch the appliance off, slide the on/off switch (1) back
to position 0.
the bristles on the brush.
Lower the bristles for cleaning carpets or rugs.
tile or marble.
Optimising the suction force
cleared regularly during use.
Emptying and cleaning the product.
Press the release latchs (12) and pull the nozzle (6)
straight off.
Empty the contents of the bowl.
To replace the nozzle, place it back onto the handle until it
(Original instructions)
Warning!
regularly.
Press the release latch (2) and pull the dust bowl (5)
straight off.
assembly (13) to empty the contents of the bowl.
To replace the dust bowl, place it back onto the handle
Warning!
A
cleaning.
9
10
water.
ever worn or damaged.
dealer:
For all
Maintenance
Your Black & Decker corded/cordless appliance/tool has been
designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
switch off.
Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
ENGLISH
-
-
7
Advertisement
Table of Contents
