Table of Contents
Advertisement
ENGLISH
Warning!
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
check that the mains voltage corresponds to the voltage on
the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the bat-
tery in the appliance/tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge nonrechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be placed in a well venti-
lated area when charging.
Electrical safety
check that the mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the charger unit with
a regular mains plug.
Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
6
(Original instructions)
Features
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Charging indicator
4. Charging socket
5. Dust bowl
6. Nozzle
7. Extention tubes
8. Floor head
Fig. A
9.
10. Filter
Installation
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
electrical outlet for chargeing the vac while it is on the wall
bracket).
Insert the charger cord into the curved slot in the wall
mount bracket leaving approximately 8-9 inches excess.
Hang the appliance on the wall by placing the opening
on the base of the vac over the hooks in the wall mount
bracket.
Assembly
These models may be supplied with some of the following
accessories:
Extention tubes (7).
Floor head (8).
Fit the extention tubes (7) together.
tubes.
Fit the narrow end of the extention tubes (7) into the appli-
ance.
Alternatively, to use as a hand-held cleaner with brush on
appliance.
Advertisement
Table of Contents
