Field Adjustments - Honeywell LC13-510 Manual

2.7 FIELD ADJUSTMENTS

There are no field adjustments for the Dual Node Module. However, the K2LCN must be
pinned for the particular node address it occupies on the LCN. Figure 2-4 shows the
pinning options for the K2LCN. The EPDGC-(I/O) board, if present, has pinning options
to set the default background shade for the CRT if a palette has not been set in a schematic
(Set Palette is a new command in Release 320). You may find additional information on
the Set Palette command in the Picture Editor Reference Manual in the Implementation/
Engineering Operations - 2 binder. The EPDGC also has a configuration option that is set
for either the Engineer's Keyboard or the Supervisor's Keyboard. (If both keyboards are
installed, the EPDGC is set up for the Supervisor's Keyboard and the Engineer's
Keyboard is connected into the Supervisor's Keyboard.) Figure 2-5 shows the keyboard
and CRT background options for the EPDGC. Also, the power supply has a pinning
option for internal or external clock. See subsection 2.9 and Figure 2-9 for additional
information. The PLCI board has several pinning options. Refer to the Programmable
Logic Controller Gateway Planning, Installation, and Service manual in the
Implementation/PLC Gateway binder for details. Figure 2-10 in subsection 2.10 covers
UCN address pinning for the NIM Modem board.
Binary
Weight
Parity
64
32
16
8
4
2
1
Jumper Removed = "1"
Overall number of jumpers
removed including the parity
jumper must be an odd number.
This example indicates node
address 03.
K2LCN
Figure 2-4 — Address Pinning on the K2LCN
Dual Node Module Service
NOTE: This text is not on the board.
2-17
TS2
9C
9D
9F
9H
2.7
7739
9/95