Assembly - Honeywell LC13-510 Manual

4
2
1
Figure 4-1 — Module Exploded View
Before inserting a replacement board:
1. Make certain that the replacement board is at a revision level equal to, or later than, the
board being replaced.
2. Make certain that any pins or switch settings (e.g., the node address on the K2LCN OR
K4LCN
See subsection 2.7 for additional

4.2 ASSEMBLY

1. Insert I/O boards (5) in the rear chassis, taking care not to damage connectors, and
secure the board retainers. Also, be sure that the I/O boards match the primary
boards.
2. Insert the power supply (4) into the chassis and secure the retainers.
3. Insert the fan assembly (3) into the chassis and secure the bail-headed screws.
4. Insert the boards (2) into the chassis and secure the retainers.
5. Install the front panel (1) to the chassis (6) and secure the quarter-turn fasteners.
Dual Node Module Service
3
NOTE
board) match those on the board being replaced.
information on pinning options.
4-2
5
6
4.2
4122
9/95