Baumatic PI1SS Instruction Manual
  1. Manuals
  2. Brands
  3. Baumatic Manuals
  4. Ventilation Hood
  5. PI1SS
  6. Instruction manual

Baumatic PI1SS Instruction Manual

Pythagora 40 cm island cooker hood
Hide thumbs Also See for PI1SS:
Table of Contents

Advertisement

Quick Links

Download this manual
PI1SS
Island cooker hood

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PI1SS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Baumatic PI1SS

Summary of Contents for Baumatic PI1SS

  • Page 1 PI1SS Island cooker hood...
  • Page 2 User Manual for your Baumatic PI1SS Pythagora 40 cm island cooker hood NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...

  • Page 3: Table Of Contents

    Contents Page Environmental note IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood Using your Baumatic cooker hood The control panel The timer button Grease filter maintenance alarm Cleaning your Baumatic cooker hood The grease filter Maintenance Removing and cleaning the grease filter...

  • Page 4: Environmental Note

    This should be undertaken by a competent person. CONFORMITY TO W.E.E.E. DIRECTIVE o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.

  • Page 5: Important Safety Information

    IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Technical Department.
  • Page 6 o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTER! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
  • Page 7 o Remember that when in extraction mode, your cooker hood is removing air from the room it is installed in. Ensure that proper ventilation measures are being observed. Note that it removes odours from the room, not steam. o Warning - Always ensure that the cooker hood has been disconnected from the power supply before carrying out any work on the hood, including cleaning and...

  • Page 8: Specifications Of Your Cooker Hood

    Specifications of your cooker hood Congratulations on purchasing a Baumatic Cooker Hood! PRODUCT DIMENSIONS: PI1SS Height (mm) 873 - 1443 Width (mm) Depth (mm) Chimney dimensions (mm) 400 x 400 Your cooker hood is fitted with: o High extraction tangential motor...

  • Page 9: Using Your Baumatic Cooker Hood

    Using your Baumatic cooker hood The control panel o Make sure that it has been installed by a suitably qualified person, as per the information contained in Baumatic’s installation instructions. o Find the control panel, which is located at the front of the cooker hood.

  • Page 10: The Timer Button

    Controlling your cooker hood o Use the ON/OFF button to switch the cooker hood on. o Use the plus and minus buttons to regulate the speed that the motor is running at. o The speed level that you have selected will appear on the LCD display.

  • Page 11: Cleaning Your Baumatic Cooker Hood

    Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, SET AT THE WALL FROM THE CABLE. Cleaning o Clean the external parts of your cooker hood with mild liquid detergent and a new damp cloth.

  • Page 12: Maintenance

    Maintenance Removing and cleaning the grease filter o Open the cover screen. o Remove the grease filter by lifting up the catch and then pulling the filter away from the hood. o Soak the grease filter in hot water and washing up liquid for about an hour.

  • Page 13: Changing A Light Bulb

    Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. o Prior to touching the light bulbs ensure they are cooled down. o Find the bulb that requires replacement.

  • Page 14: Fitting The Carbon Filters

    Fitting the carbon filters If the appliance is going to be used in recirculation mode then it is necessary to fit a pair of carbon filters. This will help to absorb unpleasant odours caused by cooking. IMPORTANT: BEFORE ATTEMPTING TO FIT OR REMOVE THE CARBON FILTERS, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY.

  • Page 15: Installation

    Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and frequency of your home. The rating plate can be found behind the grease filter, on the motor.

  • Page 16: Before Beginning Installation

    o As the colour of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the terminals in your spur box, please proceed as follows: o The blue wire must be connected to the terminal marked “N” (neutral), or coloured black.

  • Page 17: Extraction Mode Or Recirculation Mode

    o Do not tile, grout or silicone this appliance to the ceiling. This appliance is designed to be surface mounted only. o Remove any protective wrapping that has been put on the cooker hood or chimney sections, to protect them during transit. Extraction mode or recirculation mode? IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR COOKER HOOD WHETHER TO USE...

  • Page 18: Installing Your Cooker Hood

    Installing your cooker hood o We recommend that at least two people install this hood. IMPORTANT: THE MAINS SUPPLY THAT YOUR COOKER HOOD IS CONNECTED TO, MUST NOT BE SWITCHED ON UNTIL AFTER THE REST OF THE INSTALLATION PROCESS HAS BEEN COMPLETED. 1) Reach inside of the appliance, remove the tape that secures the power cable to the framework and release it.
  • Page 19 6) Turn the framework upside down (see picture), so that the upper plate is pointing upwards. 7) Remove the two nuts and bolts that hold the upper plate to the framework. 8a) If necessary adjust the height of the framework to the correct height for your particular installation.
  • Page 20 9) Lift the framework against the ceiling. The side of the framework shown in the photograph, is the side that the control panel will be on when the cooker hood is connected to the framework. 10) Mark the position of the four screw holes in the framework on the ceiling.
  • Page 21 o Fix the whole assembly to the ceiling by tightening screws through the framework, into the holes that you made in step 10. o You must make sure that these screws are fully tightened. 12) To reinforce the upper plate, you should drill into the ceiling, through the holes on each corner of the upper plate.
  • Page 22 15) If required, raise the inner chimney section to the ceiling. o There are two decorative side pieces (H) that should be used to cover the grooves in the inner chimney section. o Use an appropriate tool to cut the decorative side pieces to your required length.

  • Page 23: Connecting To External Ducting

    It should have a cross section of at least 150 cm² (please note that the ducting hose is not supplied with the appliance but is available from the Baumatic Spares Department). o The maximum distance between the coupling and your discharge outlet can be upto 3 metres long, with one 90 degree bend.

  • Page 24: Troubleshooting

    Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting the Baumatic Service Department, please refer to the checklist below. My cooker hood will not start. o Check that the hood is connected to the power supply and whether you have selected any of the fan speeds.

  • Page 25: Baumatic Ltd. Conditions Of Guarantee

    Baumatic appliance. * In addition, your appliance is covered by a 5 year parts warranty. Baumatic Ltd will provide free of charge the parts required to repair the appliance, only if they are fitted by a Baumatic engineer, for any defect that arises due to faulty materials or workmanship within a period of 5 years from the original purchase date.
  • Page 26 Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telephone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone...
  • Page 28 28 28...

Table of Contents