Baumatic P37SS Instruction Manual
  1. Manuals
  2. Brands
  3. Baumatic Manuals
  4. Ventilation Hood
  5. P37SS
  6. Instruction manual
Baumatic P37SS Instruction Manual

Baumatic P37SS Instruction Manual

90cm cooker hood
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
P37SS
Cooker Hood
my

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P37SS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Baumatic P37SS

Summary of Contents for Baumatic P37SS

  • Page 1 P37SS Cooker Hood...
  • Page 2 User Manual for your Baumatic P37SS Cooker Hood 90cm Cooker Hood NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...

  • Page 3: Table Of Contents

    Environmental note IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood 8 - 9 Using your Baumatic cooker hood 9 - 10 The control panel Switching the cooker hood on and setting the fan speed 9 - 10...

  • Page 4: Environmental Note

    ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person.

  • Page 5: Important Safety Information

    IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line.
  • Page 6 o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
  • Page 7 o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed. o Note: Your cooker hood is designed to remove cooking odours from the room and not steam. o Warning - Always ensure that the cooker hood been...

  • Page 8: Specifications Of Your Cooker Hood

    Specifications of your cooker hood Congratulations on purchasing a Baumatic cooker hood! PRODUCT DIMENSIONS Height: 595 - 1075 mm Width: 900 mm Depth: 500 mm DIMENSIONS OF CHIMNEY SECTION: Width: 375 mm Depth: 271 mm Your cooker hood is fitted with:...

  • Page 9: Using Your Baumatic Cooker Hood

    You will have to take this into account when calculating the minimum height of the cooker hood when installed. Using your Baumatic cooker hood The control panel o Make sure that it has been installed by a suitably qualified...

  • Page 10: The Cut Off Timer

    o To switch the lights off, press the Light button again. o To switch the cooker hood off, press the Add/OFF button several times until the motor stops running. The cut off timer o Whilst the cooker hood is in use, if you press the timer button once the hood will run for 5 minutes and then cut off.

  • Page 11: Cleaning Your Baumatic Cooker Hood

    Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT HAVE SWITCHED YOUR COOKER HOOD OMNI-POLAR SWITCH, SET AT THE WALL FROM THE CABLE. Cleaning o Clean the external parts of your cooker hood with mild liquid detergent and a new damp cloth.

  • Page 12: Maintenance

    Maintenance Removing and cleaning the grease filter o First remove the grease filter by pulling down on the handle and pulling them away from cooker hood. o Soak the grease filter in hot water and washing up liquid for at least 3 minutes.

  • Page 13: Changing A Light Bulb

    o Refit the grease filter once it has dried. o IMPORTANT: Let the grease filter dry thoroughly before refitting it in the cooker hood. Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY.
  • Page 14 o Then use a screwdriver remove the bulb holders and wiring from the hood. o IMPORTANT: possible to replace the bulbs individually, will necessary to obtain the bulbs, bulb holders and wiring as a complete part. This is available from our Spares Department. o Fit the replacement bulbs, bulb holders and wiring in the same manner as the originals.

  • Page 15: Fitting The Carbon Filter

    Fitting the carbon filters If the appliance is being used to be used in recirculation mode then it is necessary to fit carbon filters. This will help to absorb unpleasant odours caused by cooking. IMPORTANT: BEFORE ATTEMPTING TO FIT OR REMOVE THE CARBON FILTERS, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY.

  • Page 16: Installation

    Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and frequency in your home. The rating plate can be found behind the grease filter.

  • Page 17: Electrical Connection

    Electrical connection YOUR COOKER HOOD IS INTENDED FOR FITTED AND PERMANENT INSTALLATION. o The cooker hood’s power cable must be fitted upstream from the electrical connection, using an omni-polar switch with a contact distance of at least 3 mm. THE FUSE MUST BE RATED AT 3 AMPS.

  • Page 18: Before Beginning Installation

    Before beginning installation o Check that the product purchased is of a suitable size for the chosen installation area. In addition check whether there is an electrical socket available that will be accessible once the hood is mounted. If the product is going to be used in extraction mode, then there should also be space to connect a ducting hose to the outside.

  • Page 19: Extraction Mode Or Recirculation Mode

    Extraction mode or recirculation mode? IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR COOKER HOOD WHETHER TO USE EXTRACTION MODE RECIRCULATION MODE. What is the difference between extraction and recirculation modes? In extraction mode, the stale air will be taken out of the room via external ducting.
  • Page 20 2) Position the hood against the wall that you are intending to install it on and mark the position of the screw holes that are to be drilled (as shown in the figure below). 2a) The support screw holes are indicated by figure A in this drawing and the anchoring screw holes are indicated by figure B.
  • Page 21 3) Using a drill bit with an 8 mm diameter, make holes in the wall on the positions that you have marked in step 4) Insert rawl plugs into all of the holes that you have drilled. 5) Fasten the support screws halfway in, leaving them 10 mm out of the wall.

  • Page 22: Connecting To External Ducting

    7) Fully tighten the support screws (A) and then screw the anchoring screws (B) through the relevant holes in the cooker hood. Fully tighten the anchoring screws into the wall. Connecting to external ducting 8) Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please note that the ducting hose is not supplied with the appliance).

  • Page 23: Fitting The Chimney

    Fitting the chimney 9) Take the two chimney sections (C) and (D). o Rest the bottom of chimney section (C) on the top of the hood. You should take care to position the tabs on the chimney section into the rear of the hood.
  • Page 24 11) Take the flat bracket (E) and place it between the two pencil marks that you made in step 9 o Keeping the bracket in contact with the wall, use a pencil to mark on the wall the anchoring holes that are cut out of the bracket.

  • Page 25: Completing The Installation

    o Slide chimney section (D) inside of chimney section (C). Then secure the L shaped bracket to the wall, using the same method as you have just used to secure the lower bracket. 13) Lift chimney section (D) up to the ceiling and secure it to the L shaped bracket using the screws provided.

  • Page 26: Troubleshooting

    Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting Baumatic Customer Care Department, please refer to the checklist below. My cooker hood will not start. o Check that the hood is connected to the electricity supply o Check that the fan speed control is set correctly.
  • Page 27 Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.

  • Page 28: Contact Details

    Czech Republic United Kingdom Baumatic CR spol s.r.o. Baumatic Ltd., Průmyslová zóna Sever 696 Baumatic Buildings, 460 11 Liberec 11 6 Bennet Road, Czech Republic Reading, Berkshire RG2 0QX +420 483 577 200 United Kingdom www.baumatic.cz Sales Telephone Slovakia (0118) 933 6900 Baumatic Slovakia, s.r.o.

Table of Contents