Table of Contents
Advertisement
12
4.4.
Input phase specifications for external VD/HD signal
Set the phase relationship for external VD and HD signals as shown in the above figure.
Note that inputs other than those specified above can cause unstable internal reset.
For normal shutter mode
Continuous VD/HD signals
For restart/reset/externally triggered shutter mode
Continuous HD signal. Arbitrary timing for VD signal with the phase relationship between VD and HD within the above
specifications
4.5.
WEN output specifications
Amplitude levels are representative values when the output terminates at 10 k.
4.6.
Trigger pulse specifications
• Input impedance: 10 k or more
• Input the pulse width between 100 s and 1/4 s for DIP switch setting.
2 μs to 1/4 s
4 to 5.0 V
0 to 1.0 V
Input impedance: Enter the voltage value measured at over 10 k.
12/30
PRIMETECH ENGINEERING
Advertisement
Table of Contents
