Table of Contents
Advertisement
10
4.2.
Rear panel
[1] VIDEO OUT/DC IN/SYNC
(video output/DC power/
sync signal input/output)
terminal (12-pin connector)
[5] 75Ω termination switch
Caution
Turn off the module before setting switches.
[1] VIDEO OUT/DC IN/SYNC (video output/DC power/synchronizing signal input/output) terminal (12-pin connector)
By connecting a camera cable, the +12V DC power is supplied and a video signal is output from the camera module.
When a synchronizing signal generator is connected and an external synchronizing signal (VD/HD signal) is input, the
camera module can be operated in synchronization with an external device.
[2] DIP switches for setting shutter speed and mode
• Shutter speed setting (bits 1 to 4)
Set a shutter speed suitable for shooting conditions. The factory setting for the shutter speed is OFF.
• Charge storage mode (bit 5)
The factory setting for the high-rate scanning is FRAME.
• Restart/reset/externally triggered shutter mode switch (bits 6 to 8)
The factory setting for the switch is NORMAL.
• Gamma correction ON/OFF switch (bit 9)
This switch toggles ON and OFF for Gamma correction. The factory setting is OFF.
• Gain toggle switch (bit 0)
This switch toggles MGC (manual control) and AGC (auto control) modes. The factory setting is MGC.
[3] VD/HD signal input/output toggle switch
Set the switch to the INT side to output VD/HD signals, and set it to the EXT side to input VD/HD signals from an
external device. The factory setting for the switch is the EXT side.
[4] Manual gain control knob
This knob can be used to adjust the gain when manual adjustment is selected using the gain toggle switch among the
DIP switches ([2]).
The factory setting for the knob is Mechanical Center.
Caution
When select FRAME on Charge storage mode, please adjust this control knob from Mechanical Center to MAX side. (Due
to the characteristics of CCD)
[5] 75 termination switch
Set the switch to ON for termination. The factory setting is OFF.
[2] DIP switch for setting shutter speed and mode
[4] Manual gain control knob
10/30
PRIMETECH ENGINEERING
[3] VD/HD signal input/output switch
Advertisement
Table of Contents
