Rear Panel - Primetech PXA30SHP Operation Manual

10
4.2.

Rear panel

[1] VIDEO OUT/DC IN/SYNC
(video output/DC power/
sync signal input/output)
terminal (12-pin connector)
[5] 75Ω termination switch
Caution
Turn off the module before setting switches.
[1] VIDEO OUT/DC IN/SYNC (video output/DC power/synchronizing signal input/output) terminal (12-pin connector)
By connecting a camera cable, the +12V DC power is supplied and a video signal is output from the camera module.
When a synchronizing signal generator is connected and an external synchronizing signal (VD/HD signal) is input, the
camera module can be operated in synchronization with an external device.
[2] DIP switches for setting shutter speed and mode
• Shutter speed setting (bits 1 to 4)
Set a shutter speed. The factory setting for the shutter speed is OFF.
• Trigger mode setting (bits 5 to 6)
Set a Normal shutter mode, Restart reset mode, Non-reset mode, Reset
The factory setting is normal shutter mode.
• Scanning mode setting (bits 7 to 8)
Set a All pixels readout, Binning, 1/2high-rate scanning, 1/4high-rate scanning.
The factory setting is normal shutter mode.
• Gain switch setting (bit 9)
Set a FIX (fixing) and MANUAL (manual control) modes. The factory setting is FIX.
• Frame rate setting (bit 10)
Set a 60fps and 30fps. The factory setting is 60fps.
[3] VD/HD signal input/output toggle switch
Set the switch to the INT side to output VD/HD signals, and set it to the EXT side to input VD/HD signals from an
external device. The factory setting for the switch is the EXT side.
[4] Manual gain control knob
This knob can be used to adjust the gain when manual adjustment is selected using the gain toggle switch among the
DIP switches ([2]).
The factory setting for the knob is Mechanical Center.
[2] DIP switch for setting shutter speed and mode
[4] Manual gain control knob
10/36
PRIMETECH ENGINEERING
[3] VD/HD signal input/output switch
mode. The factory setting for the shutter