Related Manuals for Vivotek AM-10F
Summary of Contents for Vivotek AM-10F
- Page 1 VIVOTEK Multi-lens Dome Series In-ceiling Mount AM-10F Mounting Bracket Installation Guide Corresponding part number: AM-10F: 100213100G Document part no.: 625053200G Rev. 1.0 IP Sur veillance...
- Page 2 Revison History: Rev. 1.0: Initial release. AM-10F Mounting Bracket Package Contents Applications hanging rod rail main keel secondary keel Ø27.5cm ≦25mm...
- Page 3 Up to 60cm or 2 feet 30cm 60cm Compatible VIVOTEK Cameras Standard suspension ceiling tile MA9322-EHTV installation: Weight: main body: 2705g; bracket: 1084g WARNING: 1. If the need should arise, add hanging rods to strengthen your suspended ceiling structure. 2. Select a suitable location where the camera is free from accidental damage, tampering, or harsh environmental conditions.
-
Page 4: Installation
Installation 1. Remove a ceiling tile from your suspended ceiling. Drill a hole on the ceiling tile that is 275mm in diameter. OPEN Ø275 mm 275mm 2. Assemble the bracket hang rod with the two bracket stands. Bracket stand Bracket hang rod Bracket stand... - Page 5 3. Place the bracket assembly at the desired location. Spread and place the bracket stands onto the secondary keels (or ceiling rails). Secondary keel Secondary keel on the suspension ceiling on the suspension ceiling...
- Page 6 4. Fasten 2 included flathead screws to secure the positions of bracket stands on the hang rod. Once done, you can temporarily remove the assembly from the ceiling and proceed with the following steps. 5. Insert the long threaded bolt through the adapter plate and the center hole on the hang rod.
- Page 7 6. Secure the MA9322's top mounting plate to the adapter plate using the included Phillips screws. 7. Loosen or tighten the hex nuts and lock washers on the top and bottom of the hang rod. Adjust the position of the whole configuration relative to the ceiling tile. The mounting plate should be a little bit higher than the lower edge of the ceiling tile.
- Page 8 8. Tighten the hex nuts on top and below the hang rod when the adjustment is done. 9. Install the ceiling tile. 10. Lift and install the whole configuration into place. To do so, you may need to open the adjacent ceiling tile on the suspension ceiling.