Advertisement
Manual setup
1. Make sure the WiFi indicator LED on the
front panel is lit. If not, press the Mode
button for 10 seconds until it gets lit.
2. Perform a search for available wireless
networks using the personal device i.e.
laptop or mobile device.
3. Compare the list of wireless networks with
the network name which is shown on the
Pure F500/F501 label.
4. Connect by clicking on the corresponding
network name and provide the password,
which is shown on the Pure F500/F501
label called "WiFi-Key".
Power saving options
Power saving options are available via the
web interface. For more information please
visit http://router
Troubleshooting
Is the Status indicator LED off?
Check if the modem is properly connected
to the power adapter.
Check if the power adapter is connected to
an electrical outlet.
Check if the device is turned on – the ON/
OFF button should be in the "pressed" state.
If the modem is properly connected and
turned on, the Status indicator LED should
turn green after a while.
If Status indicator LED is RED for a long time,
contact your service provider.
Is the Status indicator LED red?
Contact your service provider.
Is the Uplink indicator LED off?
If the Uplink indicator LED is off, despite proper
connection, contact your service provider.
Reset the device
The reset button resets the modem to factory
settings. You can press this button with
a small pin or paperclip. See chapter 'Port
overview' to locate the pinhole.
Press and hold the button for more than
10 seconds.
EU Declaration of Conformity
Hereby, Genexis B. V . declares that the radio equipment type Pure F500/F501 is in compliance with
Directive 2014/53/EU, Directive 2009/125/EC, Directive 2011/65/EU and Delegated Directive
2015/863.
The full text of the EU declaration of conformity is available at the following internet address:
https://genexis.eu/red/pure-F500-F501
Company Name
Genexis B. V .
Company Address
Lodewijkstraat 1a
5652 AC Eindhoven
The Netherlands
Name and title of authorized person
Maarten Egmond, CTO
Frequency bands and maximum radio frequency power transmitted
The Pure F500/F501 operates in the frequency bands of 2,4 Ghz and 5Ghz.
The maximum radio frequency power transmitted in these bands is:
• 20 dBm (100 mW) (EIRP) for the 2400 MHz – 2483.5 MHz band
• 23 dBm (200 mW) (EIRP) for the 5150 MHz – 5350 MHz band
• 30 dBm (1000 mW) (EIRP) for the 5470 MHz – 5725 MHz band
* In EU, 5150 – 5350 MHz is restricted to indoor.
Signature of authorized person
Place of issue
Date of issue
Eindhoven
2020-04-09
The Netherlands
*
Advertisement
