Advertisement
Installation guide
Pure F500/F501 needs to be connected to an optical broadband network.
Multiple languages of this document and additional product information are available on
https://genexis.eu/download-portal/#pure
Getting started
Check if the following items are in
the giftbox:
• Genexis Pure F500/F501
• Power adapter
• Vertical stand
• Strain relief
• Labels (self-adhesive, 2x)
• Rubber feet (self-adhesive, 4x)
• Plugs & screws (2x)
Connecting the fiber
1. Slide the lid of the housing by sliding it
towards the portside.
2. Attach strain relief to the fiber, 58 mm
from the connector.
3. Remove the dust cap from the pigtail and
the connector, do not touch the fiber tip.
4. Connect the pigtail to the fiber interface.
5. Place strain relief in the plastic notch in
the housing at the highlighted area.
6. Slide the lid back in original position on
the housing.
Warning: do not pinch the fiber while
sliding the lid back in position.
Placement
Pure supports two placement options;
standing and mounted to a wall. It is
recommended to place the device 'away'
from obstacles and objects.
Standing
1. Attach the four rubber feet to the
Pigtail in
bottomside of the vertical stand.
fiber interface
2. Slide the vertical stand onto the bottom
of the Pure F500/F501.
3. Place the device on a flat surface.
Wall mount
1. Download and print the drilling guide from
https://genexis.eu/download-portal/#pure
2. Use the drilling guide to drill the holes,
insert plugs and put screws into place.
58mm
3. Use the wall mount points on the back
of the Pure F500/F501 to mount the
device to the screws.
Warning: do not cover the device with
anything, this will interfere with the
ventilation of the Pure.
Operation Temperature 0°C ~ 40°C
Strain relief
Setting up the Pure
1. Plug the DC adapter into an electrical
socket and connect it to power port at the
back of the Pure F500/F501.
2. Press the power button at the back of the
Pure F500/F501 to turn on the device.
3. The colored LEDs on the Pure F500/F501
panel will start blinking. This process takes
about 2 minutes.
4. If the device is connected properly and
the service is active on the fiber port, the
Status, Uplink and Internet LEDs will have
a fixed green color.
Connecting the Wireless Local Area
Network (WLAN)
Pure supports two ways to create a wireless
connection with your personal devices; via
WPS or manually. For personal devices that
support WPS, this will be the easiest method.
WPS
1. Make sure the WiFi indicator LED on the
front panel is lit. If not, press the Mode
button for 10 seconds until it gets lit.
2. Press and hold the Mode button for 3
seconds. The WiFi indicator LED will
start flashing.
3. Follow the instructions of your personal
device to complete the connection process.
Advertisement
