Fishman POWERTAP EARTH Installation Manual

Hide thumbs Also See for POWERTAP EARTH:

Download this manual

POWERTAP EARTH INSTALLATION GUIDE

514-300-185_r1

Read Me First!

*We recommend having this PowerTap system installed

by an experienced repair technician.

**Dry fit all components (Rare Earth Humbucking pickup

and Tap Body Sensor to ensure proper fit before

installation.

Tap Body Sensor Installation

The Tap Body Sensor should be installed first. The Body

Sensor installs onto the bridge plate of the instrument

directly under the saddle. Make sure the area where the

body sensor will mount is smooth. Clean this surface with

an alcohol wipe or a cotton swab moistened with

rubbing alcohol. Let dry.

Use the included mounting tool and two golf tee locaters to

ensure proper placement of the Tap Body Sensor.

To properly mount the Tap Body Sensor, insert it as shown

into the mounting tool.

Note: Before proceeding with the next 5 steps, practice installing

the Tap Body Sensor a few times with the backing paper still

attached to the pickup.

1. Peel off backing paper and add 3 small drops of Gel

Type Cyanoacrylate (Super Glue) One in the center

and ½" in from each end of the sensor.

Need help?

Do you have a question about the POWERTAP EARTH and is the answer not in the manual?

Page 1 POWERTAP EARTH INSTALLATION GUIDE 514-300-185_r1 Use the included mounting tool and two golf tee locaters to Read Me First! ensure proper placement of the Tap Body Sensor. *We recommend having this PowerTap system installed by an experienced repair technician. **Dry fit all components (Rare Earth Humbucking pickup and Tap Body Sensor to ensure proper fit before installation.
Page 2 Tap Body Sensor Installation continued… Top View: 1. Hold the sensor in the mounting tool inside the guitar in the area of the bridge plate under the bridge. (Do not press the pickup against the bridge plate at this time) 3.
Page 3 Endpin Jack Installation Push the jack through the hole and fit the small dress washer NOTE: Before installing the pickup in the soundhole, install and nut over the end of the jack. Tighten the nut with a 1/2" the endpin jack in the endblock of the guitar You may choose open-end or adjustable wrench while counter-holding the to unsolder the cable from the jack and shorten it or simply tie...
Page 4 Rare Earth Humbucking Pickup Installation NOTE: Before installing the pickup in the soundhole, insert the Tap Body Sensor plug into the jack on the Mag pickup body. It is also easier to secure all wires inside the instrument using the supplied wire clips now. The Rare Earth Humbucking pickup should be placed in the soundhole as close to the end of the fretboard as possible.

Rare earth