Adjusting The Loop Handle; Mounting And Removing The Barrier Bar - Stihl FSA 130 R Instruction Manual

11 Assembling the Trimmer / Brushcutter
► Put washers (2) on the screws (1) and insert the screws
through the holes in the loop handle and clamps.
► Attach the square nuts (7) and tighten securely. Ensure
that the handle is tight and will not move during operation.

11.2 Adjusting the Loop Handle

The loop handle can be mounted to suit the height and reach
of the operator.
To adjust the position of the loop handle:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
► Loosen the screws (2) that attach the loop handle to the
trimmer shaft.
► Slide the loop handle (1) to the desired position, subject to
the following limitations:
– Always keep the spacer (3) positioned between the loop
handle and carrier ring.
– If you are working with a mowing head, the distance
marked "a" must be less than 11.8 in. (30 cm).
– If you are working with a metal cutting attachment, a
barrier bar must be installed and the distance marked
"a" must be less than 9.8 in. (25 cm).
► Tighten the screws until the loop handle is secure and can
no longer be moved along the drive tube.
0458-725-8221-A
1
a
2
3

11.3 Mounting and Removing the Barrier Bar

11.3.1 Mounting the Barrier Bar
WARNING
To reduce the risk of serious personal injury from loss of
control or contact with the cutting attachment, use a metal
grass blade or brush knife only if the unit is equipped with a
loop handle, barrier bar and harness.
To mount the barrier bar:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
1 2
► Insert the square nuts (2) in the barrier bar (1) and line up
the holes.
► Position one clamp (5) in the loop handle (3).
► Position the other clamp (7) against the drive tube and line
up the holes in the loop handle and clamps.
► Place the barrier bar (4) in position over the holes in the
loop handle.
► Insert the screws (8) and tighten them down securely.
Ensure that the handle and barrier bar are tight and will
not move during operation.
English
3 4
5
6
7
8
27