Invacare Action Ampla User Manual page 37

1. Attach the snap hooks to the eyelets of the
transportation kit on both sides (see location of the
attachment labels).
2. Attach rear straps to the rail system referring to best
practice recommended instructions from the safety belt
manufacturer.
3. Tighten the straps.
IMPORTANT!
– Check the plungers are fully engaged on both
sides and located in the same position of the
cut-out section of the rail.
– Make sure that the angle between the rails and
the straps lies between 40° and 45°.
Fastening the 3-point passenger restraint system
1650186-A
IMPORTANT!
The illustration above may differ depending on
the restraint system supplier.
Transport
37