Table of Contents
Advertisement
Installing
1. Loosen the clamping part C by turning the lever H
counterclockwise.
2. Loosen the clamping part F by pulling the quick release
pin E.
3. Remove the push bar A.
4. Position the drip stand support B on the clamping part
C.
5. Position the clamping part D on the drip stand support.
6. Insert the push bar through the parts D, B and C into
the frame tube (only through clamping part F on the
other side).
1650186-A
7. Let the quick release pin E engage in one of the two
lower holes G on the push bar.
8. Secure the push bar by turning the lever H and D
clockwise.
Adjusting the height and angle
The rod of the drip stand must always be placed in a
vertical position, i.e. in a 90° angle to the ground, no
matter the position of the backrest or the wheelchair.
Options
29
Advertisement
Table of Contents
