Chapter 4 Operating Procedures for the DN311 (Software)
4.1 Registering the DN311
4
44
The procedures for registering the DN311s in using them connected to the S controller
are as follows:
Register DN311s in the target station using the Engineering Tool.
Supplementary Note
• Before registering DN311s, register target systems, stations, and controller folders in the
Engineeringg Tool.
• Register DN311s before creating a program that uses DN311s.
Concrete examples are given below by way of explanation. It is assumed that the
system folder (DN311TST), station folder (DN311TST) and controller folder (S3-TEST)
have been registered in advance.
(1) Starting registration
Select [Station DN311TST] in the folder column of the Product View menu of the
Engineering Tool, and double-click [Station Configuration].
The station's configuration editor starts to open the hardware configuration menu.
Figure 4-1 Product View (Configuration Editor Start)
Double-click here
model 3000 DeviceNet Module Manual (DN311/DN311A)