Table of Contents
Advertisement
Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Cleaning
your refrigerator
Removing
packaging
materials
NOTE: Do not remove any permanent
Remove tape and any inside labels (except
instruction labels inside your refrigerator. Do
the model and serial number label) before
not remove the Tech Sheet fastened under
using the refrigerator.
the refrigerator at the front.
To remove any remaining glue:
l
Rub briskly with your thumb to make a ball,
Cleaning
it before
use
then remove.
After removing all packaging materials,
OR
clean your refrigerator before
using it, if necessary. See
l
Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See "Important
Safety Instructions" on page 3.
cleaning instructions on pages
15 and 16.
Plugging
it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
&prong groundlng
type wall receptacle
See Electrical Requirements and Ground-
ing Instructions Sheet in your Literature
Package.
groundlng plug
5
Advertisement
Table of Contents
