Setting The Timer; Swing Function - DeLonghi Pinguino Air-to-Air PAC EL112CST Manual

HIGH
MEDIUM
LOW
TEMPERATURE
ORANGE LIGHT: Room conditions far
from optimal level.
GREEN LIGHT: Most people feel good
room conditions, near optimal level.
BLUE LIGHT: Best comfort level.
Perfect!
Perfect!
• The well-being feeling is a subjective condition: for this
reason, different people may judge differently the same
environmental conditions.
• In particularly severe environmental conditions (large size
of the environment, high temperature or humidity outside,
poor insulation of the room, too many of people or strong
heat load in the room, strong exposure to the sun ...) this
device may not be able to reach the best comfort level.
SILENT FUNCTION (available in conditioning mode
only)
By activating this function, the operating noise is further re-
duced. To activate it, touch on the remote control the
ton (D2). The display shows the relative symbol (C12).

SWING FUNCTION

This function moves the flap evenly distributing the air into the
room.
When the Swing button (D9) is touched, the flap will begin
Operating curve
Perfect!
to move forwards and backwards alternatively.
If touched again, the flap will be locked into its current position.
When the button is next touched, the flap will start to move for-
wards and backwards again.
Please note: in order to avoid damaging the internal mecha-
nisms, the flap must not be moved manually.
REPEAT PAIRING OF CST REMOTE CONTROL
The CST remote control is already paired to the bundled Pinguino
appliance. In case the user wants to perform a pairing with an-
other Pinguino device, or in case of a pairing of brand new CST
remote control, the user needs to put the unit in Stand-by mode
and keep touched for 10 sec sthe MODE selection button (D6) on
the CST remote control. The Led (D10) starts blinking periodi-
cally indicating the pairing phase.
The user is then asked to press for 10 sec the MODE button (C2)
on the Pinguino unit until a double beep is emitted. The pairing
phase is signaled on display by means of a fast flashing of the
dot in the middle of the digits.
When the two devices complete the pairing dialogue, the PAC
emits a double 'beep' , the display will show the normal visualiza-
tion for Standby. The pairing must be done within 60 sec.

SETTING THE TIMER

The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
How to program delayed shut down
• While the appliance is on in any operating mode, delayed
C17
shut down can be programmed.
C15
• Touch the
C8
hours (C6) light up.
C10
C14
but-
C16
• Touch the
C3
numbers of hours to shut down appears on the display.
A few seconds after the timer is set, the setting is acquired, the
C2
display shows the operating mode and the timer symbol stays lit.
Once the set time is elapsed, the air conditioner goes into stand-
by.
To cancel the timer program, touch the
twice. The timer symbol (C7) will go off.
Please note: Once the timer has been activated, by touching the
17
C5
C6
C7
timer button (D5): the timer symbol (C7) and
C9
C12
C13
C11
(D4) and (D7) buttons until the desired
C4
C1
C17
C15
C8
C10
C14
C5
C6
C7
timer button (D5)
C9
C12
C13