Table of Contents
Advertisement
Parameter
Manual Config
Restore All
Pause/Resume
Refresh
Step 2. Select line type to configure. See
Parameter
Region
Detect Line
Shield Area
Step 3. In viewing field, draw lines.
Note:
Click Redraw to delete current config.
Step 4. Adjust plate snapshot position to be in the yellow box.
Try your best to make this box match actual plate position and size in the video.
Note
Manual config set focos parameter to focus on vehicle.
Zoom：
Speed：There are 3 levels.
- and +: click
directly drag bar to zoom in and out.
Focus：
Speed：There are 3 levels.
- and +: click
directly drag bar to set focus.
Note:
This function is for ITC237-PW1B-IRZ camera.
Manual config set rear focus.
Speed：There are 3 levels.
- and +: click
directly drag bar to set rear focus.
Note:
This function is for ITC237-PU1B-IR, ITC237-PU1B-L camera only.
Restore all settings to default.
Resume：When you click Pause. Video pauses, then click Resume to
continue playing.
When you click Resume. Video continue playing, then click Resume to
pause.
View latest status.
Table 2-3
Table 2-4
Note
Set region to delete. Region is within red line.
Draw detect line of trigger of snapshot.
Detect line is green.
Set shield area. In this area, it will not identify vehicle plate. You can set up to
2 shield areas.
Shield area is within grey box.
Table 2-4
to add speed, click
to add speed, click
to add speed, click
.
to reduce speed ； or
to reduce speed ； or
to reduce speed ； or
10
Advertisement
Table of Contents
