Scott TELEMARK Manual page 10

CUFF ALIGNMENT (CANT) MECHANISM
› We recommend having your knee position measured and your
cant adjusted by an experienced boot fitter.
›
Once you determine whether you want the cuff canted in (less
cant) or out (more cant), make note of the current position of the
bottom of the cuff, making a reference mark with a pen.
›
Insert a 4mm hex key into the center of the cant mechanism.
› Rotate the outer ring with a pointed tool in its hole. Using your
reference mark, determine where you want the cuff. As the cuff
moves down in reference to your mark, you are increasing its cant.
As the cuff moves up, you are reducing its cant.
›
Holding the outer ring in the desired position, tighten the inner
hex bolt securely.
CARE AND MAINTENANCE OF YOUR SCOTT BOOTS
›
Use only soap and water to clean your boots.
›
When drying shells and liners, keep them away from direct sourc-
es of heat, i.e. radiators, open fires, etc.
› Before storing boots for a long period of time, be sure that the
liners and shells are completely dry, put the liners in the shells, and
close the buckles loosely.
MANUAL_TELEMARKT.indd 10
CALZA
A seco
re/ tog
› PER C
TA IN
sollev
cialme
› PER C
TA : c
sivam
poste
scafo
lingue
ne ne
4/8/13 2:17 PM