Step 7 - Mount To The Ceiling - Haier HCH6500ALS Installation And User Manual

NOTES:
•
If the calculated height of the vent mounting structure is shorter than
the actual height of the mounting structure, you will need to have both
the mounting structure and the vent cover cut to fit your installation. We
recommend that a stainless steel fabricator do this to ensure a straight even
cut.
•
If the calculated height of the vent mounting structure is larger than the
actual height of the vent structure, you will need to add an extension.

STEP 7 - MOUNT TO THE CEILING

IMPORTANT: If the range hood is being installed above an installed range, ensure
the range is turned off and is completely cooled before beginning installation.
1. Center the upper section of the vent mounting structure on the ceiling around
the exhaust duct opening. Ensure that:
•
The markings align with the cross braces between the ceiling joints.
•
The vent structure is square with the cooking surface below.
•
The side of the vent structure that has the arrow on it faces the front.
When installed, this is the side of the hood that will have the controls.
2. Mark the upper screw holes on the ceiling.
3. Partially screw the four mounting screws (not provided) into the ceiling where
marked.
4. Ensure that the mounting structure is square and level, and then completely
tighten the screws. The structure should now be firmly attached to the ceiling.
a
a
2½" #10 Wood Screws (4)
a
13