Troubleshooting - Panasonic ES‑ST2N Operating Instructions Manual

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service center authorized by
Panasonic for repair.
Problem
The power switch does
not turn ON.
The shaving sensor does
not respond.
16
ES-ST2N_US.indb 16
Action
Unlock the switch lock.
(See page 13.)
Depending on the beard thickness
or the amount of beard trimmings
in the shaver head, the shaving
sensor may not react and the
driving sound may not change.
This is not abnormal.
The shaving sensor may not
respond depending on the type
and quantity of the shaving gel.
This is not abnormal.
The shaving sensor may not
respond when the remaining
battery capacity is low. If this
happens, recharge the shaver.
Apply oil.
(See page 14.)
The shaving sensor may not
respond when there is not enough
oil on the blades.
Problem
Clean the beard trimmings from
the shaver.
When the shaver is extremely
dirty, remove the foil frame and
wash with water. (See page 13.)
The shaving sensor
Replace the system outer foil and/
responds even though the
or inner blades.
shaver is not in contact
Expected life of system outer foil
with the skin.
and inner blades:
System outer foil:
Inner blades:
The recommended temperature
for charging is 10 °C – 35 °C
(50 °F – 95 °F). If charged at a
The shaver cannot be
temperature other than the
charged.
recommended temperature, the
shaver may take longer to charge
or may not charge at all.
Although the shaver can be used
for about 2 weeks after a full
charge (assuming dry‑shave use
for 3 minutes per day), the usable
number of days might be lower
depending on how or where the
Operating time is short
shaver is used (for example, when
even after a full charge.
used for wet shaving).
Apply oil.
When the number of operations
per charge starts to decrease, the
battery is nearing the end of its life.
Action
Approximately 1 year
Approximately 2 years
2016/06/09 14:23:04