Graco AllControl 288711 Instructions Manual
Graco AllControl 288711 Instructions Manual

Graco AllControl 288711 Instructions Manual

Repair kits

Advertisement

Instructions
AllControl Repair Kits 288711, 289210
Model 288711: Use with M
Model 289210: Use with M
Maximum Working Pressure: 3000 psi (21 MPa, 207 bar

Important Safety Instructions

Read all warnings and instructions in this manual. Save these instructions. For detailed sprayer
information and warnings, see your Operation manual.
To reduce the risk of fluid injection or splashing in the
eyes or on the skin, relieve all fluid pressure in
system before you install, remove, or replace any
parts. See the Pressure Relief Procedure provided
in your Operating Instruction manual.
CAUTION
When repairing or cleaning the pump, never sub-
merge the pump in water or allow fluid to enter the
pressure control
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001
Project Painter 7 Sprayers
AGNUM
Project Painter 5 Sprayers
AGNUM
)
312290A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AllControl 288711 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Graco AllControl 288711

  • Page 1 When repairing or cleaning the pump, never sub- merge the pump in water or allow fluid to enter the pressure control Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001...
  • Page 2 Project Painter 7: 261805 Disassembly Assembly Grease o-ring on pressure control assembly. Push CAUTION pressure control down into machined slots in pump Be careful not to damage wires on disassembly/assembly. housing. Ensure wires are not pinched. Secure with two screws (G). Torque to 40 ±5 in-lb. Unplug electrical cord, and relieve pressure.
  • Page 3 ti10287a 312290A...
  • Page 4 Project Painter 5: 261800 Assembly Disassembly Grease o-ring on pressure control assembly. Push pressure control down into machined slots in pump housing. Secure with two screws (F). Torque to 40 ±5 in-lb. CAUTION Align gears in drive housing with pump housing and Be careful not to damage wires on disassembly/assembly.
  • Page 5 ti10290a 312290A...
  • Page 6 All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441 www.graco.com...

This manual is also suitable for:

Allcontrol 289210

Table of Contents