Brother QL-600 User Manual page 59

Troubleshooting
Problem
Label Printer is in cooling mode
Cutter error
Unable to reset an error
I want to reset the Label Printer.
Solution
The Print Head is too hot.
The Label Printer stops and resumes printing only after the Print Head has
cooled down. The head may become too hot if you are printing a large number
of labels.
When the Print Head becomes too hot, it may produce imaging outside the print
area. To avoid or delay overheating, make sure the Label Printer has adequate
ventilation and is not located in an enclosed space.
If the Label Printer must cool down because it overheated due to the type of
DK Roll you are using or the contents of the label, printing may take longer than
usual.
Note
This condition may occur more often when the Label Printer is used at high
altitude (more than 10,000 ft (3,048 m)) due to a lower air density available
to cool the Label Printer.
If a cutter error occurs, keep the DK Roll Compartment Cover closed and press
the (Power Button). The cutter moves back to the normal position and the
Label Printer turns off automatically.
After the Label Printer is turned Off, check the label outlet and remove any
jammed labels.
To reset an error:
1. Open the DK Roll Compartment Cover, and then close it.
2. If the error is not reset, press the Cut Button.
3. If the error is not reset, turn off the Label Printer, and then turn it on again.
4. If the error is not reset, contact Brother Customer Service.
You can reset the Label Printer using the Printer Setting Tool from a computer.
For more information, see Change the Label Printer Settings on page 12.
You can reset the Label Printer using the Printer buttons.
For more information, see Reset Device Settings to the Factory Settings Using
the Label Printer Buttons on page 47.
10
53