Assembling The Trimmer; Mounting The Handle - Stihl FSA 90 Instruction Manual

English

7 Assembling the Trimmer

7.1

Mounting the Handle

FSA 90
► Switch off the trimmer, push retaining latch to position
and remove the battery.
1
2
4
5
► Remove the wing screw (1).
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp molding (4).
► Fit the upper clamp (2).
► Insert the wing screw (1).
► Swing the handlebar (3) up.
► Tighten down the wing screw (1).
► Take out the screw (6).
► Position the control handle (7) on the handlebar (3),
trigger facing the gearbox, and line up the hole in the
control handle with the hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6) firmly.
52
3
6
3
8
► Push the tube (9) into the retainer (10).
The bike handle (2) need not be removed again.
7
FSA 90 R
► Switch off the trimmer, push retaining latch to position
and remove the battery.
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the drive tube
(5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle (3) and
clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
7 Assembling the Trimmer
10
9
1
2
3
4
5
6
7
0458-709-9821-C