Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ETl8CK Use And Care Manual

Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label and other
InsIde labels before using the refrigerator Any glue
left can be taken off with rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it...
1 Allow 3 Inches (7 5 cm) between overhead cab-
lnets and the refrigerator top
2 Allow at least an tnch (2 5 cm] between the refrig-
erator condenser and the wall.
3 Allow 1% inch (1.25 cm) on each srde of the re-
frigerator for ease of Installation.
4 If the refrigerator IS to be against a
wall,
you might
want to leave enough space so the door can be
opened wider
Level
refrigerator-freezer...
Use Screwdriver
to Adjust
Leveling screw
Left to Lower
1 To raise front, turn each screw to the right
2 To lower front, turn each screw to the left
3 Check with level
Clean your refrigerator before usrng It See clean-
ing Instructions on page 8.
Plug it in...
3-prong
grounding type
wall receptacle
Refrigerotol
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It
IS
recommended that a separate circuit
serving only thts appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your Irter-
ature package
4