Removing The Meat Pan And Cover; Changing The Light Bulb; Adjusting The Refrigerator Shelves; Removing The Crispers And Cover - Whirlpool ETl8CK Use And Care Manual

Unplug the refrigerator first.
I, Reach behrnd control console to find bulb
2 Remove bulb
3 Replace with a 40-w&t appliance bulb
Moving the meat pan and cover...
The meat pan and cover can be removed for
cleanina and moved to another shelf, if desired.
Removethe
meat pan first.
Removing:
1. Sltde the purr> ou' to l:op
2. Lrtt the front of meat pan
3. Side pan ?he rest of the way out
4. TII: cover up at front
5 PUI! forward and out
Replacing:
1. F!t notches underneath cover over rear and center
cross bars on shelf
2. Lower cover In place.
3. Replace meat pan In reverse order
Adjusting the refrigerator shelves...
1 Frrst, remove food from shelf
2. Slrde shelf straight out to stop
3 Lift front
Guide Stop+
Shelf Sto-
4. Slide the rest of the way out
1. Fit back of shelf on top of aurdes wrth wire stoos
Replacing Shelf:
on the bottom of gurdes.
2 Lrft front, slrde shelf In until It clears guide stops
I
Shelf Guide
Removing crispers and crisper cover.. .
Pull Out to Stop. Lift the Front
Remove the
Glass Insert,
Lift the Frame Front,
then the Back.
Glass
is heavy.
Be Careful.
Removing the Crispers:
1 Slide crisper strarght out to stop, Ikft front, then slide
the rest of the way out
2 Replace In the reverse order.
Removing Cover:
1 Push up glass Insert from bottom, then slrde out
with both hands
2 Lift front of cover frame and remove cover support
3 Loft out cover frame by pulling up and out
Replacing Cover:
1 Fit back of cover into notch supports on walls of
refrigerator, then lower front Into place
2. Replace cover support with the long tab
towards the front
Note:
If the support needs
adjustment. turn base right to lower, or left to raise
3 Slide back of glass insert into place, then lower front
Removing and Adjusting the freezer shelf...
To remove shelf:
1. Lift front slightly
2. Lift back off supports.
3. Replace in reverse order.
To adjust shelf:
Shelf
I, Remove shelf
2. Remove supports by slrding upwards.
3. Replace supports on desired level,
4. Replace shelf
6
support