Freezer Shelf; Optional Automatic Ice Maker - Whirlpool ET18AK Use & Care Manual

Removing and adjusting the freezer shelf...
To remove shelf:
1. Lift front slightly
2 Loft back off supports.
3 Replace in reverse order
To adjust shelf:
1 Remove shelf
2 Remove supports by slrding upwards
3 Replace supports on desired level.
4 Replace shelf
Support
Ice cube trays.. .
If cubes are not used, they may shrink The moving
cold arr starts a slow evaporatron The longer cubes
are stored, the smaller they get
To remove ice:
1 Hold tray at both ends.
2 Slrghtly twist
Optional automatic ice maker.. .
If you have the automatic ice maker accessory or
plan to add one later [Port No. ECKMF-83). there are a
few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down...for making ice automatically,
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa
rated, and to obtarn increased storage capacity
On
Lower Signal
Arm to Start It.
\
Raise Signal
Arm to Stop Ice Maker.
l
It
IS
normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water runnrng when Ice maker is
working. You'll hear ice fall into the bin Don't let
these sounds bother you.
l
The Ice maker WIII not operate until the freezer is
cold enough to make ice. This can take overnight.
l
Because of new plumbing connections. the first
ice may be discolored or off-flavored Drscard the
first few batches of ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, If necessary. turn
the Freezer Control toward A.
l
If You remove the ice bin, raise the signal arm to
shut off the Ice moker. When you return the bin.
push It all the way in and lower the arm to the ON
posItron.
l
If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes In the ice bin can also
become smaller by evaporation.
l
The ice maker water supply should not be soft-
ened water. The chemicals could damage the ice
maker molds,