Whirlpool ET18AK Use & Care Manual page 6

Changing the light bulb.. .
Unplug the refrigerator first.
1. Reach behind control console to find bulb.
2. Remove bulb
3 Replace with a 40-w& appliance bulb.
Moving the meat pan and cover...
Glass is heavy.
Be Careful.
Frame
Frame
support
Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use
your refrigerator.
\
Removing the Meat Pan:
I, Slide the meat pan out to stop.
2. Lift the front.
3. Slide pan the rest of the way out.
4. Replace in reverse order
Removing the cover:
1. Push up glass insert from bottom, then slide out
with both hands.
2. Lift cover frame out of frame support
3. Tilt front of frame support up, lift at back, and pull
support straight out.
4. Replace in reverse order.
To remove shelves:
1. Tilt up at front.
2. Lift up at back.
3. Pull shelf straight out
To replace:
1. Guide the rear hooks into the slots in the shelf
supports.
2. Tilt up front of shelf until hooks drop into slot. Lower
front of shelf to level position.
Removing crispers and crisper cover. . .
Pull Out to Stop. Lift the Front
Remove the
Glass Insert.
Lift the Frame Front,
then the Back.
Glass is heavy.
Be Careful.
Removing the Crispers:
1. Slide crisper straight out to stop, lift front, then slrde
the rest of the way out.
2 Replace in the reverse order
Removing Cover:
I. Push up glass insert from bottom, then sltde out
with both hands.
2. Lift front of cover frame and remove cover support
3 Lift out cover frame by pulling up and out.
Replacing Cover:
1 Frt back of cover into notch supports on walls of
refrigerator, then lower front into place.
2 Replace cover support with the long tab
towards the front Note: If the support needs
adjustment, turn base rrght to lower, or left to raise.
3. Slide back of glass insert Into place, then lower front.
6