Recommended Grounding Method - Whirlpool ET18AK Use & Care Manual

Install properly.. .
Remove sales labels.. .
II I I
ml
----
t
.
1 Allow 3 inches (7.5 cm] between overhead cabl-
nets and refrrgerator top.
2. Allow at least an inch (2 5 cm] between the
refrigerator condenser on the back and the wall.
3 Allow 1/2 inch (1.25 cm] on each side of the
refrigerator for ease of installation
4 If the refrigerator is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider.
Level refrigerator-freezer.. .
Leveling screw
Rc!lse 1
Use Screwdriver
to Adjust
Lower
Right to Raise;
Left to Lower
1. To raise front, turn each screw to the right
2 To lower front, turn each screw to the left
3. Check wrth level
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solutron (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before usrng It.
See cleanrng instructions
onpageB.-
Plug it in...
j-prong grounding
type wall receptacle
t
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned oft with a switch
or pull chain. See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.