Table of Contents
Advertisement
Install properly...
0
I.
1. Allow 3 inches (7.5 cm] between
overhead
cab-
inets and the refrigerator
top.
2. Allow at least an inch (2.5 cm) between
the re-
frigerator
condenser
on the back
and the wall
3. Allow % inch (1.25 cm) on each
side of the re-
frigerator
for ease of installation.
4. If the refrigerator
is to be against
a wall, you
might want to leave
extra space
on the hinge
side so the door can be opened
wider.
Level refrigerator-freezer...
This refrigerator
has 2 threaded
levelling
legs that
are shipped
in a separate
package.
1. Screw these legs all the way into bolt holes at
the bottom corners of refrigerator.
Roll refrigera-
tor into place.
2. Lower legs just enough
to lift rollers off floor.
3. Adjust each
leg until the refrigerator
won't rock.
4. Adjust front legs to level the refrigerator.
-To raise corners, turn legs in direction
shown.
-To lower corners, turn legs in direction
shown.
5. Check
with level.
Remove sales labels...
Remove
the Consumer
Buy Guide
label,
tape
and
any
inside
labels
before
using
the
re-
frigerator.
To remove
any remaining
glue:
1. Rub briskly
with thumb
to make
a ball
then
remove.
OR
2. Soak
area
with
liquid
hand
dishwashing
detergent
before
removing
glue as described
in step I.
DO NOT USE rubbing
alcohol
or flammable
or
toxic
solvents,
such as acetone,
gasoline,
car-
bon tetrachloride,
etc. These can damage
the
material.
NOTE: DO NOT REMOVE ANY PERMANENT
IN-
STRUCTIONS
LABELS INSIDE
YOUR REFRIGER-
ATOR.
Do not remove
the Tech sheet fastened
under
the refrigerator
at the front.
Clean it...
Clean
your refriger-
ator before
using it.
See cleaning
instruc-
tions on page
8.
Plug it in...
J-PRONG
GROUNDING
TYPE WALL RECEPTACLE
I
REFRIGERATOR
POWER CORD
3-PRONG
-
GROUNDING
PLUG
RECOMMENDED
GROUNDING
METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere
fused
and
properly
grounded
electrical
supply
is
required.
It is recommended
that a separate
cir-
cuit serving
only this appliance
be provided.
Do not use an extension
cord.
Use a recepta-
cle which
cannot
be turned
off with a switch
or
pull chain.
See individual
electrical
requirements
and grounding
instruction
sheet in your literature
package.
Advertisement
Table of Contents
