Fresh Water System; Command Center - Jayco EAGLE FW 2020 Owner's Manual

Table of Contents

Section 8: Plumbing System

NOTE: When using shore

power all 4 LEDs will light.

If disconnected from shore

power, 3 LEDs will light to

indicate a full charge (4th LED

may blink).

The LEDs on the panel indicate the following:

C = Charge at 12.7 volts

G = Good at 12.1 volts

F = Fair at 11.6 volts

L = Low at 6.0 volts

Water pump switch (if so equipped) may be located

on the monitor panel, the utility center or both. When

the water pump switch is ON (it will light up), the water pump will run until it reaches 45

lbs. of pressure. It will recycle when pressure drops. Turn the switch OFF when the water

pump is not being used.

Water heater switch(s) (if so equipped) are located on the monitor panel, and will light

up when turned on. The "LP GAS" water heater switch (12V) enables propane operation of

the water heater, and the "ELECTRIC switch (120V) enables electric operation of the water

heater. Normally both switches should be turned on to provide the fastest hot water recovery

time. The water heater can be operated in electric only or gas only modes by pressing each

switch independently. If the RV is equipped with a tankless water heater, there will be only

an LP Gas switch on the command center panel.

DSI FLT - Direct Spark Ignition Fault (if so equipped): This light located between the

water heater switches will indicate a problem with the LP portion of the water heater. When

the LP GAS switch is turned on, the light will blink quickly 3 times and the water heater will

ignite. The light will then remain off. If the light comes on and stays on, it indicates the gas

side of the water heater has not fired and there is a problem with the igniter.