Install Properly; Level Refrigerator-Freezer; Remove Soles Labels; Clean It - Whirlpool ET14AK Use & Care Manual

Install properly.. .
I
lrl
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
1 Rub brrskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solutron (1
teaspoon detergent In 1 quart worm water) before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
1 Allow 3 Inches (7 5 cm) between overhead cab-
inets and the refrigerator top
2 Allow at least an inch (2.5cm) between the refrig-
erator condenser and the wall
3 Allow I/Z Inch j 125 cm] on each side of the re-
frrgerator for ease of lnstallatlon
4 If the refrigerator IS to be against a wall, you might
want to leave enough space so the door can be
opened wrder
Level refrigerator-freezer.. .
1 Keep the 4 bolts that hold refrtgerator in shipping
crate They are the levelling legs,
2 Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator. Roll refrigerator into
place
3 Lower legs just enough to lift rollers off floor
4. Adjust each until the refrigerator won't rock
5. Adjust front legs to level the refrigerator.
- To rarse corners,
turn legs in direction shown
- To lower
corners, turn legs in direction shown
6 Check with level.
Clean it...
Clean your refrigerator
before using It.
See cleaning instructions b
onpage8. _
Plug it in...
3-prong
grounding type
wall receptacle
rong
ing plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
qurred It IS recommended that a separate crrcuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See
individual electrrcal require-
ments and grounding Instructton sheet
ID
your liter-
ature package