Table of Contents
Advertisement
AMETEK CTS
1.
General
1.1.
Intended use
Coupling decoupling networks of the CDN 118A series are used for simulating conducted electromagnetic inter-
ference effects for immunity testing to international, national, and manufacturers' standards.
The CDN's are designed for full compliance conducted electromagnetic compatibility (EMC) test requirements.
The application range is for testing of industrial, light industrial, household or commercial equipment, including
many product family and product standards as per following basic standards
Only qualified personnel who deal with attendant hazards in impulse generators, are allowed to perform installa-
tion and servicing. Before put in service the attached safety and user manual must be readed and applied. The
Safety and user manual are an essential part of the equipment and must be available to the operator at all times.
The user must obey all safety instructions and warnings.
It is the user's responsibility to ensure that the test rig does not emit excessive electromagnetic interference (EMI)
that might affect other equipment. The test system itself does not produce any excessive radiation; however, the
injection of interference pulses into the EUT can result in the device and/or its associated cables radiating EMI.
To avoid radiating unwanted interference the standards organizations recommend that the test setup be located
in a Faraday cage.
1.2.
Safety label on the device
Please take note of the following explanations of the symbols used in order to achieve the optimum benefit from
this manual and to ensure safety during operation of the equipment.
CAUTION
WARNING
Operating manual
This symbol warns of a potential risk of shock hazard. The symbol on an instrument
shows that it can source 1000 volt or more, including the combined effect of normal
and common mode voltages. Use standard safety precautions to avoid personal con-
tact with these voltages.
This symbol indicates where a caution is required. Refer to the operating instructions
located in the manual to protect against personal injury or damage the equipment
The CAUTION symbol indicates a potential hazard. It calls attention to a procedure,
practice or condition which, if not followed, could possibly cause damage to equipment.
Such damage may invalidate the warranty. If a CAUTION is indicated, do not proceed
until its conditions are fully understood and met.
The WARNING symbol indicates a potential hazard. It calls attention to a procedure,
practice or condition which, if not followed, could possibly cause bodily injured or
death. If a WARNING is indicated, do not proceed until its conditions are fully under-
stood and met.
V 1.00
CDN 118A series
4 / 26
Advertisement
Table of Contents
