Whirlpool TimeSmart ED20TWXDN02 Use & Care Manual page 9

hlNC (CONT.1
4. Make sure that the doors are even. If the freezer
6. If you are not hooking up an ice maker, connect
door is lower than the fresh food door, turn the
the refrigerator to the electrical supply after
leveling screw on the freezer side clockwise. If leveling, and then see page 12.
the fresh food door is lower, turn the leveling
screw on that side clockwise.
5. Replace the base grille.
- ---
ATTACHING
THE ICE MAKER TO A WATER
Read all directions carefully before you be@.
Electrical Shock Hazard
Unplug the refrigerator before installing
ice maker.
Failure to do so can result in death or
electrical shock.
IMPORTANT:
e Use copper tubing only and check for leaks.
@ Install ice maker tubing in areas where
temperatures are above freezing.
Tools required:
0 Standard screwdriver
0 7/16-inch and M-inch open-end wrenches or
two adjustable wrenches
8 X-inch nut driver
l
N-inch drill bit
l
Hand drill or electric drill (properly grounded)
NOTE: Your appliance dealer has a kit available
with a %-inch saddle type shut-off valve, a union,
and copper tubing. Before purchasing, make sure
a saddle type valve complies with your local plumb-
ing codes. Do not use a piercing type or G-inch
saddle valve which reduces water flow and clogs
more easily.
Cold water supply
The ice maker water valve contains a flow washer
which is used as a water pressure regulator. The
ice maker needs to be connected to a cold water
line with water pressure limitations of 20-120 psi. If
a problem occurs, call your utility company.
1MPORTANT:
* It may take up to 24 hours for your ice maker to
begin producing ice.
@ If operating the refrigerator before installing the
water connection, turn ice maker to the OFF
position to prevent operation without water.
l
All installations must be in accordance with local
plumbing code requirements.
INSTALLATION IS NOT WARRANTED
BY REFRIGERATOR OR ICE MAKER
MANUFACTURER.