Installing Your Refrigerator; Unpacking Your Refrigerator - Whirlpool TimeSmart ED20TWXDN02 Use & Care Manual

INSTALLING YOUR REFRIGERATOR
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Removing packaging materials
cleaning before use
Remove tape and any labels from your refrigerator
After you remove all of the packaging materials,
before using (except the model and serial
clean your refrigerator before using it if
number label).
needed. See the cleaning instructions
To remove any remaining tape or glue, rub the
on page 24 for more information.
area briskly with your thumb. Do not use sharp
instruments, rubbinq alcohol, flammable fluids, or
UNPACKING
YOUR REFRIGERATOR
abrasive cleaners. These products can damage the
surface of your refrigerator. For more information,
see "Important Safety Instructions" cn page 3.
NOTE: Do not remove any permanerit instruction
labels inside your refrigerator, or the Tech Sheet
that is tastened under the front.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused,
grounded electrical supply is required. It is recom-
mended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot
be turned off by a switch. Do not use an extension
cord. Refer to the Electrical Requirements and
Grounding Instructions Sheet in your Literature
Package for more details.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, turi the
Refrigerator Control to OFF and then unplug the
refrigerator. When you are finished with any of
these steps, plug the refrigerator in and reset the
Refrigerator Control to the desired se:ting.
Before you move your refrigerator int#I its final
location, it is important to make sure you have the
proper electrical connection.
EIHTRKA~
REQUIREMENTS
3-prong grounding
type wall receptacle
7