Whirlpool TimeSmart ED20TWXDN02 Use & Care Manual page 11

Side by side refrigerator/freezer
Table of Contents

Advertisement

ATTACHING
ME ICE MAKER TO A WATER SUPPLY
KONL)
--~~~~--~~~-
B-w-
WR
-s------
-
-
__
---
----
-
---
-
--
__-
-.---
Connecting to refrigerator
NOTE: The first step for connecting
the water line to
your refrigerator is different depending on the type
of water valve provided with your refrigerator. See
the diagrams at right to determine the style of valve
you have. (On kit models, assemble water valve to
refrigerator per kit instructions.)
1.
For style #l, disconnect
the tube clamp on the
Style #I valve
back of the product and insert the copper tubing
through the clamp, as shown at the right. Re-
move the tape label from the valve inlet and
insert copper tubing until it bottoms out (approxi-
mately %-inch). Tighten nut by hand as much as
possible; then turn the nut an additional
l/i turn
using a wrench. Do not overtighten.
Re-attach
the tube clamp and tube to the back of the
cabinet. Skip to step 2.
Water inlet
For style #2, disconnect
the tube clamp on the
back of the product and insert copper tubing
through the clamp as shown at the right. Attach
the copper tube to the valve inlet using a com-
pression nut and sleeve as shown. Tighten the
compression
nut. Do not overtighten.
Reattach
the tube clamp and tube to the back of the
cabinet. Move to step 2.
Style #2 valve
2. Turn shut-off
valve ON. CHECK FOR LEAKS.
TIGHTEN ANY CONNECTIONS
(INCLUDING
00
CONNECTIONS
AT THE VALVE) OR NUTS
00
00
THAT LEAK.
00
3. The ice maker is equipped with a built-in water
00
00
strainer. If local water conditions
require periodic
cleaning or a well is your source of water supply,
-0
a second water strainer should be installed in
00
00
the %-inch water line. Obtain a water strainer
00
from your nearest appliance dealer. Install at
either tube connection.
4. After installation,
connect the refrigerator to the
electrical supply and push it back into place.
5. Check to make sure the refrigerator is level. (See
"Leveling"
on page 8.)
Use only
X-inch
copper tubing
\
from cold
\
water line
Tube clamp
X-inch com-
pression
-
nut and sleeve

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents