Step 4: Verify That The Update Was Successful - Digi Connect Sensor Update Manual

Update the modem firmware over the air (FOTA)
Note All devices in the request must have the same modem revision and update string. Devices will
individually connect as scheduled and perform the update.
See the Digi Remote Manager User Guide and Digi Remote Manager Programming Guide on the Remote
Manager Documentation tab for more information.

Step 4: Verify that the update was successful

1. In Remote Manager, click on the Device Management tab.
2. Display the device properties.
3. Click Refresh at the bottom of the device page.
Click Yes if prompted to send as an offline operation.
The information will update the next time the device is scheduled to connect to the Remote
Manager.
4. Close the Device tab.
5. Re-open the device tab by double-clicking on your device.
6. Select System Information > Mobile information.
7. Note the new value for Revision, which should now be 20.00.015.
Digi Connect® Sensor Telit Modem Firmware Update - Verizon
Step 4: Verify that the update was successful
10