4 Functionality
4.3
Push Support
4.3.1 General
The pushing process is done by using three main groups of COSEM objects as follows:
• Triggering Objects
• Script Table
• Push Set-up
Below figure depict the COSEM objects are involved in Pushing process and their relationship:
As shown in above figure, the meter can be woken up by a trigger (internally or externally) to
connect to network and exchange data with Central System. This is called Triggering Process. The
following COSEM objects are considered to provide triggering:
• Push action scheduler – Interval_1
• Push action scheduler – Interval_2
• Push action scheduler – Interval_3
• Alarm Monitor 1
• Alarm Monitor 2
• Auto Answer (SMS)
A trigger calls a script in Push Script Table (0-0:10.0.108.255) and the called script invokes the
"Push" method of relevant "Push Setup" objects. At the end, the "Push" method of "Push Setup"
object sends the specified message/data to the Central System.
COM200 module - Product Manual 1.0
Node sayaç Çözümleri Ltd. Şti.
Metering Solutions
Figure 4: Pushing Process
Page 12 of 25
MetCom Solutions GmbH
www.node.com.tr
Need help?
Do you have a question about the COM200 Series and is the answer not in the manual?