Page 3
Remove the Battery Cover NOTE: PowerView Shutters with a divider rail or split tilt will have two battery wands, one in the top rail and one in the bottom rail. Remove the battery cover from ■...
Page 4
INSTALLATION Testing the Louvre Section Testing the louvre section with the programming button will allow you to ensure that the motor and power source are working correctly. Tilt louvres open by hand. ■ Press the programming button on the back side ■...
Page 5
Tilt louvres to the closed position IMPORTANT: If you have more than one remote, see “Adding Additional Remote(s) to the PowerView ® Shade Network” in the PowerView Motorisation Remote Control Guide. Joining a Louvre Section to a Group IMPORTANT: The louvre section will not operate using the remote until it has been joined to a group.
Page 6
Remote and/or PowerView Surface Remote Operation ® ® ® For information regarding operation and programming of the PowerView remote, refer to your PowerView Motorisation Remote Control Guide or to the online PowerView Step-by-Step Guide. PowerView Scene Controller ® For information regarding operation and programming of the PowerView Scene Controller, refer to your PowerView Motorisation Scene Controller Guide or to the online PowerView Step-by-Step Guide.
Page 7
2. Refer to “Joining a Louvre Section to a Group” on page 5 to program the louvre section to a group. Troubleshooting If your louvres do not operate correctly: With PowerView Shutters, first review the guide that came with your control device. ■...
Page 8
TROUBLESHOOTING Problem The louvre section is not responding to the PowerView remote. Solution IMPORTANT: A louvre section will not operate until it is joined to a group. Check that the correct group number is selected on the remote. Check that the batteries in the remote are correctly inserted and are fresh. The LED lights that backlight the remote should come on full bright when ■...
Page 9
TROUBLESHOOTING Problem Batteries in the battery wand need to be replaced. Solution Replace the batteries in the battery wand. Squeeze the cap latch to release the cap Battery and remove the cap from the battery wand. Wand Install the batteries according to the instructions on the battery wand label.
Need help?
Do you have a question about the PowerView and is the answer not in the manual?
Questions and answers