Check Wheel Nut Torque; Check Tire Pressure - Toro REELMASTER 3100-D Operator's Manual

Before Operating
1
1. Hydraulic Tank Cap
3. Remove the dipstick from the filler neck and wipe it
with a clean cloth. Insert the dipstick into the filler
neck; then remove it and check the level of fluid.
Fluid level should be within 6 mm of the mark on
the dipstick.
4. If the level is low, add appropriate fluid to raise the
level to the full mark.
5. Install the dipstick and cap onto the filler neck.

CHECK TIRE PRESSURE

The tires are overinflated for shipping. Release some of
the air to reduce the pressure. Correct air pressure in
tires is 97–124 kPa.
IMPORTANT: Maintain recommended pressure in
all tires to assure a good quality of cut and proper
machine performance. DO NOT UNDER INFLATE.
CHECK THE REEL-TO-BEDKNIFE
CONTACT
Each day before operating, check the reel-to-bedknife
contact, regardless of whether the quality of cut was
previously acceptable. There must be light contact across
the full length of the reel and bedknife (refer to
Adjusting The Reel-to-Bedknife Contact in the cutting
unit operator's manual).
12
Figure 6

CHECK WHEEL NUT TORQUE

Torque wheel nuts to 61–88 Nm after 1–4 hours of
operation and again after 10 hours of operation and
every 200 hours thereafter. Failure to maintain proper
torque could result in failure or loss of a wheel and may
result in personal injury.
WARNING
Torque wheel nuts to 61–88 Nm after 1–4 hours of
operation and again after 10 hours of operation and
every 200 hours thereafter. Failure to maintain
proper torque could result in failure or loss of a
wheel and may result in personal injury.