Advertisement
6. After cleaning
the gas tube opening and
ports, replace the burner cap and pan.
(Burner pan must be replaced over
burner base before replacing burner cap.
Do not operate burners without burner
pans in place.) To replace burner cap,
make sure cap is properly aligned and
leveled. Find the recessed locating tabs
on the burner cap (see illustration)
and
place cap over the white ignitor in the
burner base.
7. Turn on the burner to determine if it will
light. If the burner does not light after
cleaning,
contact
an authoriied
Whirlpool'
service technician.
Do not
service the sealed burner yourself.
Removing
the oven door
Removing the oven door will help make it
easier to clean the oven.
Burn and Electrical
Shock Hazard
Make sure all controls are OFF and the
oven is cool before removing oven door.
Failure to do so could result in burns or
electrical shock.
To remove:
1. Open the door as far as it will go.
2. Remove the screws on each side of the
oven door.
3. Close the door about ?4 of the way.
4. Lift the door up and off the hinges.
4Q
--.\
_
-/'
.
i
/.'
/
m
&
/
.:::
......
'
screw
.......
........
........
........
........
0
........
.........
.........
........
........
........
........
.......
.....
:.Y
'A
7
19
Advertisement
