Table of Contents
Advertisement
SE-923 Scan Engine Integration Guide
Laser On Time
Parameter # 0x88
This parameter sets the maximum time decode processing continues during a scan attempt.
It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar codes beginning
on page 5-102 that correspond to the desired on time. Times less than 1.0 second must have
a leading zero. For example, to set an on time of 0.5 seconds, scan the bar code below,
then scan the "0" and "5" bar codes. If you make an error, or wish to change your
selection, scan the CANCEL bar code on 5-104.
LASER ON TIME
5-10
Advertisement
Table of Contents
