Table of Contents
Advertisement
Installation, Operations and Maintenance Manual
4. Usage and Operation for ReliaGear ND
G&T Devices
WARNING
This equipment may contain voltages at a level
which may cause death or serious injury. This
equipment should only be operated by qualified
personnel. Follow usage instructions and safety
precautions. Only use this equipment for its
nameplate rating.
4.1 Grounding
1. Disconnect the grounding bus from
terminal.
2. Remove grounding bus and clear the bus away
from the G&T.
3. If the opposite terminal location (upper or lower)
is needed, refer to section 4.3 for instructions.
Figure 10: Lower terminal configuration
without ground bus installed
Courtesy of NationalSwitchgear.com
Figure 11: Upper terminal configuration
the
4. Ensure proper procedures are followed for
removing
switchgear door.
5. Insert the device in the switchgear breaker
compartment using ReliaGear ND Installation,
Operations, & Maintenance Manual, document
number: 1VAL107501-MB section 5.10.
Figure 12: Lower terminal configuration in
1VAL064601-MB Rev C
without ground bus installed
the
breaker
and
disconnected position with field
distributors installed
opening
the
8
Advertisement
Table of Contents
