Table of Contents
Advertisement
Appendix A. Cable and connector
specifications
IMPORTANT NOTE
The maximum cable lengths supported vary widely between devices and
cables. It may be possible to use cables that are longer than those specified
below with certain PCs and peripherals but this cannot be guaranteed. If you
experience problems try using shorter cables.
A1. Keyboard, monitor and mouse to SmartView
Cable specification:
All of the shared devices plug directly into the relevant ports at the rear of the
SmartView. If you use an AT style keyboard you will need an AT (5 pin DIN female)
to PS/2 (6 pin mini-DIN male) converter. Keyboard, monitor and mouse extension
cables can be used to increase the distance from SmartView up to 10m. Most
keyboards and mice will also operate at distances of 20 metres.
A2. SmartView to PCs 1 to 16
Cable specifications:
Video - 15 pin high density male D connector to 15 pin high density male D
connector wired as a standard VGA PC to monitor cable. There are two types
commonly available. The best type cables which will give excellent quality are
constructed with coaxial cable cores. Cheaper 'data' cables are often used, but can
degrade video quality if used over longer distances. Avoid using 'data' cables longer
than 2 metres unless the video quality is not important. Good quality coaxial video
cables may be run at distances up to 50 metres with little loss of video quality.
Keyboard and PS/2 mice - 6 pin mini-DIN male connector to 6 pin mini-DIN male
connector with all lines connected straight through (1-1,2-2 etc.). If the PC has a 5-
pin DIN AT style keyboard connector you will need a PS/2 to AT keyboard adapter
6-pin mini-DIN female to 5-pin DIN male (readily available). Cables should be no
longer than 30 metres.
SmartView
Installation and Use
Page 37
Advertisement
Table of Contents
