Fanimation PYLON LP8277 Series Instructions Manual page 14

How to Operate Your Ceiling Fan (Continued)
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting
process. (If not used for long periods of time, remove
battery to prevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
4. To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches
firmly up or down. (Figure 4)
NOTE: Factory setting is all up. Do not use this
position.
5. Remote functions: (Figure 5)
• Indicator LED light: fan speed
• button: Turns fan off.
• Fan Speed:
Turns fan on and turns speed up.
Turns fan on and turns speed down.
• Light button: Turns light on and off.
Increases light output level.
Decreases light output level.
• Sleep Timer:
Tap and the fan and light will turn off after
1 hour.
Tap and the fan and light will turn off after
3 hours.
Tap and the fan and light will turn off after
6 hours.
6. If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Slide the reverse switch on the motor assembly to the
opposite position and turn fan on again. (Figure 6)
Reverse Switch Information
Season Rotation Direction
Summer Counterclockwise
Winter Clockwise
Switch Position
Left
Right
14
12V 23A
Battery (1 pcs)
Figure 3
ON DIP
1 2 3 4 5
Dip Switch
Figure 4
Figure 5
Figure 6
Remote
Reverse
Switch