Download Print this page

Troubleshooting - Air Hogs Zero Gravity Nano Wall Climber Instruction Manual

Advertisement

Available languages

Available languages

By turning the steering wheel on the controller/charger, you can make your Wall Climber spin around on the spot.
RIGHT SPIN
PROBLEM
Vehicle will not run.
Red light "Charging" AND Green light
"Power" on the controller flashing
consecutively when charging.
Green light "Power" on the controller
flashing at a slow rate while Red light
"Charging" is off during charging/
play mode.
Suction doesn't work (fan has stopped).
Vehicle will not climb walls.
Vehicle does not drive straight.
Vehicle slips climbing the walls.
Vehicle falls off the wall.
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply
with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio
communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that interference will not occur. If this toy does cause
interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be
useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio technician
for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc.) could
result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to operate the equipment.
This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
BATTERY SAFETY INFORMATION:
• Batteries are small objects.
• Replacement of batteries must be done by adults.
• Follow the polarity (+/-) diagram in the battery compartment.
• Promptly remove dead batteries from the toy.
• Dispose of used batteries properly.
• Remove batteries for prolonged storage
• DO NOT incinerate used batteries.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• DO NOT mix old and new batteries or types of batteries (i.e.
alkaline/standard).
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• DO NOT short-circuit the supply terminals.
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Customer Care: 1-800-622-8339 www.spinmaster.com/customercare
Fax: 416-364-8005 Web: www.spinmaster.com
Email: toys@spinmaster.com
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
Spin Master Toys UK Ltd., Meadowbank, Furlong Road, Bourne End, Bucks,
SL8 5AJ, United Kingdom Customer Service: 0870 850 8408
Email: ukservice@spinmaster.com
Spin Master France – 36 rue de Silly – 92100 Boulogne Billancourt – France
Service Après-Vente – Numéro vert : 0800 803 355 ou
E-mail : Jouets@spinmaster.com – Site internet : www.spinmaster.fr
Turn the Steering Wheel RIGHT to
make the vehicle spin clockwise.

TROUBLESHOOTING

SOLUTION
1. Power switch is off. Turn on.
2. Controller battery is installed with incorrect polarity. Check the (+) and (-) markings to make sure
the battery is properly aligned.
3. Batteries are drained. Charge batteries and/or install new batteries.
1. Make sure the power switch on the vehicle is positioned at "off" and then recharge.
1. Change controller batteries or install new batteries.
1. Remove debris by blowing gently on the fan area located on the bottom of the Zero Gravity Nano™.
1. Suction jammed. Turn vehicle off for 30 seconds then restart.
1. Check trim.
2. Make sure surface is clean of dirt/dust.
3. Make sure surface is neither too rough or too smooth.
4. Make sure surface is flat.
1. Clean the tires with a damp rag.
2. Fold up the fabric skirts to 45° for a better seal prior to use.
1. Make sure to discharge and then charge again for 30 to 50 minutes.
2. Clean tires and make sure your wall and floor are also clean.
3. Check the fabric skirts for damage. If they have been pulled loose, tape them back on with flexible tape.
4. Make sure surface is flat.
Your Zero Gravity Nano™ is equipped with a Lithium Polymer battery.
!
• Never charge battery unattended.
• Charge battery in isolated area. Keep away from
flammable materials.
• Do not expose to direct sunlight.
• There is a risk of the batteries exploding,
overheating, or igniting. Do not disassemble,
modify heat, or short circuit the batteries. Do not
place them in fires or leave them in hot places.
• Do not drop or subject to strong impacts.
• Do not allow the batteries to get wet.
®, TM and © 2009 Spin Master Ltd. Air Hogs ® is a
registered trademark of Spin Master Ltd. All rights
reserved. Conforms to product safety standards
ASTM F963, EN71 regulatory requirements.
• Products and Colours May Vary. Please retain this
information for future reference. • Please remove all
packaging materials before giving to children. • An adult should periodically check this toy to
ensure no damage or hazards exist, if so, remove from use. • Children should be supervised
during play. • Keep addresses and phone numbers for future reference. • The item inside this
package may vary from the photographs and/or illustrations. Patent Pending. MADE IN CHINA.
20019139, 20019140, 20021554
GBL English
T44362_0001_20019139_GBL_IS_R3
SPINS
LEFT SPIN
WARNING:
4
Turn the Steering Wheel LEFT to
make the vehicle spin counter-clockwise.
• Only charge the batteries with the specified
Spin Master™ battery charger.
• Only use the batteries in the device specified by
Spin Master™.
• Carefully read the instruction guide, and use the
batteries correctly.
• In the unlikely event of leakage or explosion use
sand or a chemical fire extinguisher for the
battery.
Contains LiPo battery pack. • Battery pack must be
recycled or disposed of properly. • If at any time in the
future you should need to dispose of this product
please note that Waste Electrical Products should NOT
be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority
or retailer for recycling advice. (Waste Electrical and
Electronic Equipment Directive).
TM

Advertisement

loading