Advertisement
Available languages
Available languages
WHEEL ALIGNMENT
1 If the vehicle turns to
the left, move the wheel
alignment lever to the
right until the vehicle
drives straight.
2 If the vehicle turns to
the right, move the wheel
alignment lever to the left
until the vehicle drives
straight.
Wheel Alignment
Lever
PROBLEM
Vehicle is slow or will not move.
Vehicle does not drive in a straight line.
Vehicle is damp or wet.
My vehicle and/or controller is dirty.
Vehicle is not responding or driving on
its' own.
NOTE: If normal function of the product is disturbed or interrupted, strong
electro-magnetic interference may be causing the issue. To reset product,
turn it completely off, then turn it back on. If normal operation does not
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital de-
vices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. Because this toy generates,
uses, and can radiate radio frequency energy, there can be no guarantee that interference will not occur. If not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interfer-
ence), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the
dealer or an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component
(crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority
to operate the equipment.
CANADIAN Class B statement: This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
RSS-310 Statement: This device complies with Industry Canada Iicence-exempt RSS standard(s).
Carrier frequency: 49.860 MHz, Field strength: 79.1 dBuV/m at 3 m.
SPIN MASTER LTD., 450 FRONT STREET WEST, TORONTO, ON M5V 1B6 CANADA
Customer Care: 1-800-622-8339 Fax: 416-364-8005
Email: customercare@spinmaster.com
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville,
NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F, Chinachem Golden Plaza, 77 Mody Rd.,
Tsimshatsui E., Kowloon, HK
Imported by:
SPIN MASTER INTERNATIONAL, S.A.R.L., 16 AVENUE PASTEUR, L-2310, LUXEMBOURG
www.spinmaster.com
1
2
TROUBLESHOOTING GUIDE
CAUSE
1. Batteries in the vehicle and/or
controller need to be replaced.
2. Vehicle is out of range of controller.
3. There is hair or debris stuck in the
wheels or wheel axles.
4. Batteries are installed incorrectly.
5. Improper surface for vehicle.
Vehicle requires wheel alignment.
Inappropriate driving surface
/conditions.
1. Inappropriate driving surface.
2. Dirty hands.
1. Using another vehicle/controller of
the same frequency.
2. Radio Interference from another
source.
NOTE: As the wheels turn left
or right, Tow Mater™ also looks
left or right
1. Replace batteries in the vehicle and/or controller with new, fresh
batteries.
2. Move closer to the vehicle.
3. With the vehicle and controller turned off, have an adult carefully
remove the hair or debris from the wheels or wheel axles.
4.With the vehicle and controller turned off, have an adult check that the
batteries are installed correctly.
5. Change your play area to a hard, flat surface. Examples of poor
play surfaces are thick carpet, grass or sand. Examples of good play
surfaces are non-carpeted floors or concrete.
DO NOT PLAY ON THE STREET OR IN AN AREA WHERE THERE
IS NO ADULT SUPERVISION.
Refer to Wheel Alignment guide above.
Turn the controller off and ask an adult to safely remove the vehicle from
the water source. It's recommended to discontinue use of the toy. Once
dry, the vehicle should be properly disposed of.
Ensure the controller and vehicle are off. Have an adult remove the
batteries first and replace the battery covers. Slightly damp a clean cloth
in clean plain water and wipe toy clean. Wipe dry. DO NOT IMMERSE IN
WATER and DO NOT USE ANY CHEMICALS. Let the toy completely
dry before putting batteries back into clean, dry battery compartment.
1. Check your vehicles frequency and be sure TO NOT operate multiple
vehicles of the same frequency.
2. Keep clear of other sources of radio interference (i.e.: CB radios, large
buildings, electrical wires, etc.).
resume, move the product to another location and try again. To ensure
normal performance, change the batteries, as low batteries may not allow
full function.
© Disney/Pixar. Air Hogs
®
, related trademarks & © 2011 Spin Master Ltd.
All rights reserved. This product conforms to safety requirements of ASTM F963 &
CHPA. • Please retain this information for future reference. • Please remove all
packaging materials before giving to children. • An adult should periodically check
this toy to ensure no damage or hazards exist, if so, remove from use.
• Children should be supervised during play. • Keep addresses and phone numbers
for future reference. • The item inside this package may vary from the photographs
and/or illustrations. MADE IN CHINA.
20038708
NTL English
T43004_0001_20038708_NTL_IS_R1
When finished playing, be sure to
turn the controller and vehicle OFF
Turn Vehicle OFF
O
Turn Controller OFF
O
SOLUTION
REV 0
I
I
TM
Advertisement
